Figure 254: Installing A Side Air Filter In A Qfx3008-I Interconnect Device Side; Fan Tray - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
626
Ensure that you have the following parts and tools available to remove a bottom air filter
from a QFX3008-I Interconnect device:
Electrostatic discharge (ESD) grounding strap
To install an air filter (see Figure 254 on page 626
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Align the filter with the fan tray module so that it slides into the chassis at a slant.
2.
Slide the air filter all the way into the slot.
3.
Hold the handle and the screw of the cover panel and align the cover panel at a slight
4.
angle to attach the handle end to the slot.
Push the screw end of the cover panel into the chassis.
5.
Tighten the captive screw on the cover panel using your fingers.
6.
Figure 254: Installing a Side Air Filter in a QFX3008-I Interconnect Device Side Fan Tray
and Figure 255 on page 627):
Copyright © 2018, Juniper Networks, Inc.