Juniper QFabric QFX3000-G Hardware Documentation page 624

QFX3000-G QFabric System Hardware Documentation
See Also
Adding a New QFX3008-I Interconnect Device to the QFabric System
574
NOTE: After you power off a wiring tray, wait for at least 60 seconds before
you turn it back on. After you power on a wiring tray, wait for at least
60 seconds before you turn it back off.
NOTE: The power supplies in a QFX3008-I Interconnect device continue to
use a small amount of power when the C19 wiring tray power switch is in the
off position. The status LEDs on each power supply blink amber because the
power supply fans are not operating. This is expected behavior.
Connecting AC Power to a QFX3008-I Interconnect Device with Single-Phase Wiring
Trays on page 411
Connecting AC Power to a QFX3008-I Interconnect Device with Three-Phase Delta
Wiring Trays on page 418
Connecting AC Power to a QFX3008-I Interconnect Device with Three-Phase Wye
Wiring Trays on page 422
To add a new QFX3008-I Interconnect device to the QFabric system:
Install the new device and connect the QFX3008-I Interconnect device to power. See
1.
"Installing and Connecting a QFX3008-I Interconnect Device" on page 389
information about mounting the device in a rack and connecting the device to power.
Connect the new QFX3008-I Interconnect device to the QFX3000-G QFabric system
2.
control plane network. See
Copper-Based QFX3000-G QFabric System Control Plane Network" on page 505
"Connecting a QFX3008-I Interconnect Device to a Fiber-Based QFX3000-G QFabric
System Control Plane Network" on page
"Connecting a QFX3008-I Interconnect Device to a
528.
Copyright © 2018, Juniper Networks, Inc.
for more
or