Figure 51: Management Panel Components On The Qfx5100-96S - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
86
CAUTION: Do not use the
under the direction of Juniper Networks Technical Assistance Center (JTAC).

Figure 51: Management Panel Components on the QFX5100-96S

1— Status LEDs
2— em1–SFP management Ethernet port (C1)
Cage (socket for either 1 GbE copper SFP or
fiber SFP)
3— Reset
button, see caution statement above
The management panel consists of the following components:
Status LEDs
ALM–Alarm
Unlit indicates the switch is halted or that there is no alarm.
Red indicates a hardware fault, such as a power failure or a system shutdown due
to system over-heating.
Amber indicates a major or minor alarm.
SYS–System
Unlit indicates the switch is powered off or halted.
Solid green indicates that Junos OS for QFX Series is loaded on the switch.
Blinking green indicates the switch is:
A participating member in a Virtual Chassis.
A participating leaf device in a Virtual Chassis Fabric (VCF).
button to restart the power sequence unless
Reset
4— em0–RJ-45 (1000 Base-T) management
Ethernet port (C0)
5— RJ-45 console port (C0N) )
6— USB port
Copyright © 2018, Juniper Networks, Inc.