Figure 164: Installing A Three-Phase Wiring Tray With A Power Cord Installed - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

QFX3000-G QFabric System Hardware Documentation

Figure 164: Installing a Three-Phase Wiring Tray with a Power Cord Installed

Mixing different types of wiring trays in the same chassis is not a

supported configuration.

To meet safety and electromagnetic interference (EMI)

requirements and to ensure proper operation, a QFX3008-I Interconnect

device must be adequately grounded before it is connected to power.

For installations that require a separate grounding conductor to the chassis,

use the protective earthing terminal on the QFX3008-I Interconnect device

to connect to earth ground. For instructions on connecting a QFX3008-I

Interconnect device to ground using a separate grounding conductor, see

"Connecting Earth Ground to a QFX3008-I Interconnect Device" on page

A QFX3008-I Interconnect device receives additional grounding when you

plug the wiring tray in the device into a grounded AC power outlet by using

the AC power cord appropriate for your geographical location. See

Cord Specifications for a QFX3008-I Interconnect Device with Three-Phase

Delta Wiring Trays" on page 285

QFX3008-I Interconnect Device with Three-Phase Wye Wiring Trays" on

"AC Power Cord Specifications for a

Table of Contents