Figure 277: Removing A Qfx-Pfa-4Q Expansion Module From A Qfx5100-24Q-Aa; Device; Figure 278: Qfx-Em-4Q Expansion Module - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Installing an Expansion Module in a QFX5100 Device
672
Figure 277 on page 672 shows removing a QFX-PFA-4Q expansion module from the port
panel of a QFX5100-24Q-AA switch.
NOTE: You must take the QFX-PFA-4Q offline before replacing it.
Figure 277: Removing a QFX-PFA-4Q Expansion Module from a QFX5100-24Q-AA Device
Installing an Expansion Module in a QFX5100 Device on page 672
Installing and Removing QFX5100 Device Hardware Components on page 665
Field-Replaceable Units in a QFX5100 Device on page 75
QFX5100 Device Hardware Overview on page 63
The QFX5100-24Q device allows up to two expansion modules to be added to the port
panel to increase port density. The QFX5100-24Q device holds two bays of expansion
modules that can be mixed and matched as desired. The supported modules are:
QFX-EM-4Q–Each module adds four Quad Enhanced Small Form-Factor Pluggable
(QSFP+) ports. See Figure 278 on page

Figure 278: QFX-EM-4Q Expansion Module

EX4600-EM-8F–Each module adds eight 10 Gigabit SFP+ ports. See
Figure 279 on page 673.
672.
Copyright © 2018, Juniper Networks, Inc.