Juniper QFabric QFX3000-G Hardware Documentation page 625

Copyright © 2018, Juniper Networks, Inc.
Power on the new QFX3008-I Interconnect device:
3.
Attach the ESD grounding strap to your bare wrist and connect the strap to the
a.
ESD point on the chassis.
Ensure that the power supplies are fully inserted in the chassis.
b.
Ensure that the source power cords are installed correctly for each wiring tray, and
c.
the wiring trays are fully inserted in the chassis.
Switch on the site circuit breakers.
d.
Set a wiring tray's switch to the ON (|) position. Observe the power supply and
e.
wiring tray faceplate LEDs. If the wiring trays are installed correctly and functioning
normally, the LEDs light green and remain constantly lit.
Repeat Step 5 for the second wiring tray installed in the device.
f.
The QFabric system upgrades the QFX3008-I Interconnect device to the version of
4.
software installed on the QFX3100 Director devices. Verify that the QFX3008-I
Interconnect device has been upgraded to the correct version of software using the
show version component all
partition CLI.
NOTE: It takes some time for the software upgrade to occur. Do not
proceed to the next step until the
verifies that the software has been upgraded.
Verify that the QFX3008-I Interconnect device has been added to the QFX3000-G
5.
QFabric system using the show fabric administration inventory interconnect-devices
operational mode command from the QFabric default partition CLI.
Write down the serial number of the new device from the output of the show fabric
6.
administration inventory interconnect-devices command.
From the QFabric director, enter the following configuration mode CLI commands to
7.
remove the previous Interconnect device from the inventory of QFabric system
components and associate the serial number of the new device with the alias of the
previous device.
root@fabric# delete fabric aliases interconnect-device
old-serial-numberalias-name
root@fabric# set fabric aliases interconnect-device new-serial-numberalias-name
Chapter 39: Removing or Replacing a Device
operational mode command from the QFabric default
show version component all
command
575