Figure 232: Removing A Power Supply From A Qfx3100 Director Device - Juniper QFabric QFX3000-G Hardware Documentation

Related
Documentation
Installing a Power Supply in a QFX3100 Director Device (includes video)
Copyright © 2018, Juniper Networks, Inc.
Taking care not to touch power supply components, pins, leads, or solder connections,
4.
place one hand under the power supply to support it. Grasp the power supply handle
with your other hand and pull the power supply completely out of the chassis.
Place the power supply in the antistatic bag or on the antistatic mat.
5.

Figure 232: Removing a Power Supply from a QFX3100 Director Device

Ejector
lever
Video: Removing a Power Supply from a QFX3100 Director Device
Installing a Power Supply in a QFX3100 Director Device (includes video) on page 589
AC Power Supply in a QFX3100 Director Device on page 34
The AC power supply in a QFX3100 Director device is a hot-removable and hot-insertable
field-replaceable unit (FRU) located on the far right side of the rear panel. Two AC power
supplies are installed in a QFX3100 Director device. You can remove and replace a single
AC power supply without powering off the QFX3100 Director device or disrupting QFX3100
Director device functions.
Before you install an AC power supply in the QFX3100 Director device:
Ensure that you understand how to prevent electrostatic discharge (ESD) damage.
See "Prevention of Electrostatic Discharge Damage" on page
Ensure that you have the following parts and tools available to install an AC power supply:
ESD grounding strap
NOTE: Each AC power supply must be connected to a dedicated AC power
source outlet.
To install an AC power supply in the QFX3100 Director device (see
Chapter 40: Replacing QFX3100 Components
360.
Figure 233 on page 590):
589