Juniper QFabric QFX3000-G Hardware Documentation page 567

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
Chapter 35: Cabling a Copper-Based Control Plane for the QFX3000-G QFabric System
Connect the other end of that cable to the appropriate member and port on the second
4.
Virtual Chassis. This should be the same member number and port number that you
connected to in Step 2. For example, if you connected the first cable to
the first Virtual Chassis, you connect the second cable to
Virtual Chassis.
Repeat this procedure for each Node device.
5.
Connecting a QFX3500 Node Device to a QFX3008-I Interconnect Device on page 548
Connecting a QFX3600 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 512
on
ge-0/0/0
on the second
ge-0/0/0
517