Figure 241: Installing An Ac Power Supply In A Qfx3008-I Interconnect; Device - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

QFX3000-G QFabric System Hardware Documentation

Documentation

Removing a Wiring Tray from a QFX3008-I Interconnect Device

Figure 241: Installing an AC Power Supply in a QFX3008-I Interconnect Device

AC Power Supply in a QFX3008-I Interconnect Device on page 56

Removing an AC Power Supply from a QFX3008-I Interconnect Device on page 605

The wiring tray in a QFX3008-I Interconnect device is a hot-insertable and hot-removable

field-replaceable unit (FRU). Two wiring trays are installed in the rear of the chassis.

Before you remove a wiring tray from the device, ensure that you understand how to

prevent ESD damage. See

Ensure that you have the following parts and tools available to remove a wiring tray from

a QFX3008-I Interconnect device:

Electrostatic discharge (ESD) grounding strap

Phillips (+) screwdriver, number 1

Replacement wiring tray

Do not leave the wiring tray slot empty while the device is

operational. Replace the wiring tray promptly.

"Prevention of Electrostatic Discharge Damage" on page

Chapters

Table of Contents