Juniper QFabric QFX3000-G Hardware Documentation page 562

QFX3000-G QFabric System Hardware Documentation
Table 145: QFX5100-48S Node Device-to-Virtual Chassis Copper-Based Control Plane Port Assignments (continued)
Member 0
Node 31: ge-0/0/31
Related
Documentation
Connecting a QFX3600 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network
512
Member 1
Node 63: ge-1/0/31
To connect a QFX5100 Node device to the QFX3000-G QFabric system control plane
network):
Connect one end of the first RJ-45 patch cable to the management port (labeled
1.
on the Node device management board.
Connect the other end of that cable to the appropriate member and port on the Virtual
2.
Chassis. See Table 145 on page
Connect one end of the second RJ-45 patch cable to the second management port
3.
(labeled C1 ) on the Node device management board.
Connect the other end of that cable to the appropriate member and port on the second
4.
Virtual Chassis. This should be the same member number and port number that you
connected to in Step 2. For example, if you connected the first cable to ge-0/0/0 on
the first Virtual Chassis, you connect the second cable to ge-0/0/0 on the second
Virtual Chassis.
Repeat this procedure for each Node device.
5.
Connecting a QFX5100 Node Device to a QFX3008-I Interconnect Device on page 545
Connecting a QFX3600 Node Device to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 512
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFX series devices in your network to two Virtual Chassis composed of
four EX4200 or four EX4300 switches each. QFX3600 Node devices have two
management ports with RJ-45 connectors. Use the management ports to connect the
QFX3600 Node device to each Virtual Chassis (see
Member 2
Node 95: ge-2/0/31
511.
Figure 220 on page
Copyright © 2018, Juniper Networks, Inc.
Member 3
Node 127: ge-3/0/31
C0
513).
)