Juniper QFabric QFX3000-G Hardware Documentation page 720

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Removing an Expansion Module from a QFX5100 Device
670
NOTE: If you have a Juniper Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
AC Power Supply for a QFX5100 Device on page 94
Field-Replaceable Units in a QFX5100 Device on page 75
Port Panel of QFX5100-48S and QFX5100-48SH Devices on page 77
Management Panel of a QFX5100 Device on page 85
AC Power Cord Specifications for a QFX Series Device on page 292
Connecting AC Power to a QFX5100 Device on page 443
Connecting DC Power to a QFX5100 Device on page 446
Removing a Power Supply from a QFX5100 Device on page 666
The expansion modules used in QFX5100-24Q and QFX5100-24Q-AA devices are
hot-removable and hot-insertable field-replaceable units (FRUs): You can remove and
replace them without powering off the switch or disrupting switch functions.
NOTE: You must take the QFX5100-24Q-AA switch offline, before replacing
the QFX-PFA-4Q expansion module.
Before you begin removing an expansion module from the switch:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge
(ESD) damage (see "Prevention of Electrostatic Discharge Damage" on page
If there are any transceivers installed in the expansion module, remove them before
you remove the expansion module. For instructions on removing transceivers, see
"Removing a Transceiver from a QFX Series Device" on page
Ensure that you have the following parts and tools available:
ESD grounding strap
Phillips screwdriver, number 2
A replacement optional module or cover panel
An antistatic bag or antistatic mat
. Failure
360).
707.
Copyright © 2018, Juniper Networks, Inc.