Installing A Qfx5100 Node Device - Juniper QFabric QFX3000-G Hardware Documentation

CHAPTER 31

Installing a QFX5100 Node Device

Installing and Connecting a QFX5100 Device
Copyright © 2018, Juniper Networks, Inc.
Installing and Connecting a QFX5100 Device on page 433
Unpacking a QFX5100 Device on page 434
Mounting a QFX5100 Device in a Rack or Cabinet on page 435
Connecting Earth Ground to a QFX5100 Device on page 442
Connecting AC Power to a QFX5100 Device on page 443
Connecting DC Power to a QFX5100 Device on page 446
Connecting a QFX Series Device to a Management Console on page 450
You can mount a QFX5100 device:
Flush with the front of a 19-in. four-post rack. Use the standard mounting brackets
provided with the switch for this configuration.
Recessed 2 in. (5 cm) from the front of a 19-in. four-post rack. Use the extension bracket
provided in the standard mounting kit for this configuration. Recessed mounting is
primarily used in enclosed cabinets.
To install and connect a QFX5100 device:
Follow the instructions in
1.
Determine how the device is to be mounted.
2.
Flush or recessed mounted in a rack or cabinet, see
a Rack or Cabinet" on page
Follow the instructions in:
3.
Connecting Earth Ground to a QFX5100 Device on page 442
a.
"Connecting AC Power to a QFX5100 Device" on page 443
b.
to a QFX5100 Device on page 446
"Unpacking a QFX5100 Device" on page
"Mounting a QFX5100 Device in
435.
434.
or Connecting DC Power
433