Juniper QFabric QFX3000-G Hardware Documentation page 614

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

QFX3000-G QFabric System Hardware Documentation

Interconnect device

Fabric manager

Fabric control

Diagnostic routing engine

Director group

0281112011000023

0281112011000082

The final output of the

interconnect-device

shutting down and can be removed when the LCDs are off

to 4 minutes after first seeing this message before following the

instructions in Step

Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD

point on the chassis.

Set the wiring tray switch to the OFF (O) position. Observe the wiring tray LEDs. The

power supply LEDs should turn off (appear unlit). Repeat this step for the second

wiring tray.

After you power off a wiring tray, wait for at least 60 seconds before

you turn it back on. After you power on a wiring tray, wait for at least

60 seconds before you turn it back off.

request fabric administration power-off

command is the following message:

to power off the device.

The device is

. Wait at least 3

Chapters

Table of Contents