Figure 191: Connecting An Ac Power Cord To An Ac Power Supply In A Qfx3500; Figure 192: Connecting An Ac Power Cord To An Ac Power Supply In A Qfx3600 Or Qfx3600-I Device - Juniper QFabric QFX3000-G Hardware Documentation

Copyright © 2018, Juniper Networks, Inc.
Figure 191: Connecting an AC Power Cord to an AC Power Supply in a QFX3500 Device
Cord retainer
Figure 192: Connecting an AC Power Cord to an AC Power Supply in a QFX3600 or
QFX3600-I Device
If the AC power source outlet has a power switch, set it to the OFF (O) position.
6.
NOTE: The device powers on as soon as power is provided to the power
supply. There is no power switch on the device.
Insert the power cord plug into an AC power source outlet.
7.
If the AC power source outlet has a power switch, set it to the ON (|) position.
8.
Verify that the AC and DC LEDs on each power supply are lit green.
9.
If the amber fault LED is lit, remove power from the power supply, and replace the
power supply (see "Removing a Power Supply from a QFX3500 Device" on page 648
or "Removing a Power Supply from a QFX3600 or QFX3600-I Device" on page
Do not remove the power supply until you have a replacement power supply ready:
the power supplies or a blank cover panel must be installed in the device to ensure
proper airflow.
CAUTION: Replace a failed power supply with a blank panel or new power
supply within 1 minute of removal to prevent chassis overheating.
Chapter 32: Installing a QFX3600 Node Device
658).
465