Figure 32: Single-Phase Wiring Tray - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

QFX3000-G QFabric System Hardware Documentation

A QFX3008-I Interconnect device has two protective earthing

terminals provided on the rear of the chassis. The first pair is sized for M6

screws and is located below the wiring tray on the bottom left corner at the

rear of the chassis. The second pair is sized for UNC ¼-20 screws and is

located below the second wiring tray on the bottom right corner at the rear

of the chassis. The grounding points are spaced at 0.625 in. (15.86 mm). Only

one of the two protective earthing terminals needs to be permanently

connected to earth ground.

Three LEDs on the faceplate indicate the status of each power channel. Each wiring tray

also has a power switch on the faceplate. See

Figure 33 on page

Figure 32: Single-Phase Wiring Tray

Figure 32 on page 60

Table of Contents