Juniper QFabric QFX3000-G Hardware Documentation page 514

QFX3000-G QFabric System Hardware Documentation
464
on the device chassis to connect to the earth ground. For instructions on
connecting earth ground, see
Device" on page 480
Devices" on page
the power supply in the device into a grounded AC power outlet by using
the AC power cord appropriate for your geographical location (see
Power Cord Specifications for a QFX Series Device" on page
Install the power supply in the chassis. For instructions on installing a power supply in
a QFX3500 device, see "Installing a Power Supply in a QFX3500 Device" on page
For instructions on installing a power supply in a QFX3600 or QFX3600-I device, see
"Installing a Power Supply in a QFX3600 or QFX3600-I Device" on page
NOTE: Each power supply must be connected to a dedicated power source
outlet.
To connect AC power to a QFX3500, QFX3600, or QFX3600-I device:
Attach the grounding strap to your bare wrist and to a site ESD point.
1.
Ensure that the power supplies are fully inserted in the chassis and the latches are
2.
secure. If only one power supply is installed, ensure a that blank cover panel is installed
over the second power supply slot.
Locate the power cord or cords shipped with the device; the cords have plugs
3.
appropriate for your geographical location. See
QFX Series Device" on page
WARNING: Ensure that the power cord does not block access to device
components or drape where people can trip on it.
Connect each power supply to the power sources. Insert the coupler end of the power
4.
cord into the AC power cord inlet on the AC power supply faceplate.
Push the power cord retainer onto the power cord (see
5.
Figure 192 on page 465).
"Connecting Earth Ground to a QFX3500
or "Connecting Earth Ground to QFX3600 or QFX3600-I
462. The device gains additional grounding when you plug
"AC Power Cord Specifications for a
292.
Copyright © 2018, Juniper Networks, Inc.
"AC
292).
646.
660.
Figure 191 on page 465 or