Figure 260: Removing A Rear Card From A Qfx3008-I Interconnect Device - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

Documentation

Installing a Rear Card in a QFX3008-I Interconnect Device

Grasping the ejector levers, pull the rear card about halfway out.

Taking care not to touch the leads, pins, or solder connections, place one hand

underneath the rear card to support it, and slide it out of the chassis completely.

Place the rear card in the antistatic bag or on the antistatic mat.

Figure 260: Removing a Rear Card from a QFX3008-I Interconnect Device

Rear Cards in a QFX3008-I Interconnect Device on page 55

Rear Card LEDs on a QFX3008-I Interconnect Device on page 733

Installing a Rear Card in a QFX3008-I Interconnect Device on page 641

There are eight rear cards in a QFX3008-I Interconnect device. The rear cards are installed

horizontally in the rear of the chassis in the slots labeled

for a QFX3008-I Interconnect Device" on page

Do not lift modules by holding the ejector levers. The levers cannot

support the weight of the module. Lifting the module by the levers might

bend the levers, and the bent levers prevent the board from being properly

seated in the chassis.

Chapter 41: Replacing QFX3008-I Components

"Slot Numbering

Table of Contents