Juniper QFabric QFX3000-G Hardware Documentation page 632

QFX3000-G QFabric System Hardware Documentation
582
Connecting a QFX3600 Node Device to a Copper-Based QFX3000-G QFabric
System Control Plane Network on page 512
Connecting a QFX3600 Node Device to a Fiber-Based QFX3000-G QFabric System
Control Plane Network on page 537
Connecting a QFX3500 Node Device to a Copper-Based QFX3000-G QFabric
System Control Plane Network on page 515
Connecting a QFX3500 Node Device to a Fiber-Based QFX3000-G QFabric System
Control Plane Network on page 540
Connect power to the new device to connect to the fabric. For information on
5.
connecting power for your QFX switch model, see the appropriate QFX hardware
guide.
The QFabric system begins to upgrade the new device or to the version of software
installed on the QFX3100 Director devices.
Verify that the new device has been upgraded to the correct version of software using
6.
the show version component all
partition CLI.
NOTE: It takes some time for the software upgrade to occur. Do not
proceed to the next step until the
verifies that the software has been upgraded.
Verify that the new device is inserted into the fabric using the
7.
operational mode command from the QFabric default partition
inventory node-devices
CLI.
user@qfabric> show fabric administration inventory
Item
Node group
NW-NG-0
P5502-C
P5502-C
P8207-C
P8207-C
TA3713470056
TA3713470056
TR0214080017
TR0214080017
Interconnect device
IC-TB3713490033
TB3713490033/RE0
IC-TB3714010454
TB3714010454/RE0
Fabric manager
FM-0
Fabric control
FC-0
FC-1
Diagnostic routing engine
operational mode command from the QFabric default
show version component all
Identifier
Copyright © 2018, Juniper Networks, Inc.
command
show fabric administration
Connection Configuration
Connected Configured
Disconnected
Disconnected
Connected Configured
Connected
Disconnected
Disconnected
Disconnected
Disconnected
Connected Configured
Connected
Connected Configured
Connected
Connected Configured
Connected Configured
Connected Configured