Juniper QFabric QFX3000-G Hardware Documentation page 636

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
586
NOTE: When you remove multiple devices from a rack, remove the device in
the top of the rack first and proceed to remove the rest of the devices from
top to bottom.
Before removing a QFX3500 device from a rack:
Ensure that the rack is stable and secured to the building.
Ensure that there is enough space to place the removed QFX3500 device in its new
location and along the path to the new location.
Read "General Safety Guidelines and Warnings" on page
Ensure that the QFX3500 device has been safely powered off (see Powering Off a
QFX3500 Device) and that you have unplugged (disconnected) the power cords.
Ensure that you have disconnected any cables or wires attached to the QFX3500
device ports.
Ensure that you have the following parts and tools available:
A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack
mounting screws, for mounting the QFX3500 device on the rack.
To remove a QFX3500 device from a rack or cabinet:
Have one person support the weight of the device while another person uses the
1.
screwdriver to remove the mounting screws that attach the chassis front-mounting
brackets to the rack or cabinet.
Remove the QFX3500 device from the rack or cabinet.
2.
Use the screwdriver to remove the mounting screws that attach the mounting blades
3.
attached to the rear of the rack or cabinet.
Place the removed screws and mounting blades in a labeled bag. You will need them
4.
when you reinstall the chassis.
Transport the QFX3500 device to your desired new location.
5.
Mounting a QFX3500 Device in a Rack or Cabinet on page 475
329.
Copyright © 2018, Juniper Networks, Inc.