Figure 230: Qfx3600 Node Device Fiber-Based Control Plane Connections For; Qfx3000-M Qfabric System - Juniper QFabric QFX3000-G Hardware Documentation

Related
Documentation
Connecting a QFX3600 Node Device to a Fiber-Based QFX3000-G QFabric System
Control Plane Network
Copyright © 2018, Juniper Networks, Inc.
Chapter 36: Cabling a Fiber-Based Control Plane for the QFX3000-G QFabric System
Do not let fiber-optic cables hang free from the connector. Do not allow
fastened loops of cables to dangle, which stresses the cables at the
fastening point.
Connecting a QFX5100 Node Device to a QFX3008-I Interconnect Device on page 545
Connecting a QFX3600 Node Device to a Fiber-Based QFX3000-G QFabric System
Control Plane Network on page 537
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFX Series devices in your network to two Virtual Chassis composed of
EX4200 or EX4300 switches. If you are creating a fiber-based control plane network,
you use eight EX4200-24F or four EX4300-48P Ethernet switches in each Virtual Chassis.
QFX3600 Node devices have RJ-45 and SFP management ports. Use the SFP
management ports (labeled
Virtual Chassis (see Figure 230 on page

Figure 230: QFX3600 Node Device Fiber-Based Control Plane Connections for

QFX3000-M QFabric System

Use the following QFX3600 Node devices and EX Series switches for a fiber-based
QFX3000-G QFabric system control plane network:
QFX3600 Node devices.
Virtual Chassis EX4200-24F or EX4300-48P switch members with an SFP+ uplink
module installed.
Before you begin to connect a QFX3600 Node device to the fiber-based QFX3000-G
QFabric system control plane network:
C0S and C1S ) to connect the QFX3500 Node device to each
537).
EX Series EX Series
537