Figure 247: Installing A Side Fan Tray In A Qfx3008-I Interconnect Device - Juniper QFabric QFX3000-G Hardware Documentation

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
CAUTION: The fan trays can be removed and replaced while the QFX3008-I
Interconnect device is operating. However, you must replace the fan tray
within 2 minutes of removing the fan tray to prevent overheating of the
chassis.
To install a fan tray in a QFX3008-I Interconnect device (see
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the chassis.
Hold the handle of the fan tray with one hand and support the weight of the tray with
2.
the other hand. Align the tray with the fan tray guides on the fan tray slot. Slide in the
fan tray until it is fully seated in the chassis.
Hold the handle and the screw of the cover panel and align the cover panel at a slight
3.
angle to attach the handle end in to the slot.
Push the screw end of the cover panel in to the chassis.
4.
Tighten the captive screw on the cover panel using your fingers.
5.

Figure 247: Installing a Side Fan Tray in a QFX3008-I Interconnect Device

Cooling System and Airflow in a QFX3008-I Interconnect Device on page 48
Removing a Side Fan Tray from a QFX3008-I Interconnect Device on page 614
Chapter 41: Replacing QFX3008-I Components
Figure 247 on page 617):
617