Figure 269: Installing A Power Supply In A Qfx3600 Or Qfx3600-I Device - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

Documentation

Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD

point on the chassis.

Taking care not to touch power supply components, pins, leads, or solder connections,

remove the power supply from its bag.

Using both hands, place the power supply in the power supply slot on the rear panel

of the device and slide it in until it is fully seated and the locking lever slides into place.

Figure 269: Installing a Power Supply in a QFX3600 or QFX3600-I Device

Each power supply must be connected to a dedicated power source

If you have a Juniper Care service contract, register any addition,

change, or upgrade of hardware components at

https://www.juniper.net/customers/support/tools/updateinstallbase/

to do so can result in significant delays if you need replacement parts. This

note does not apply if you replace existing components with the same type

of component.

AC Power Supply for a QFX3500, QFX3600, or QFX3600-I Device on page 110

DC Power Supply for a QFX3500, QFX3600, or QFX3600-I Device on page 112

Field-Replaceable Units for QFX3600 and QFX3600-I Devices on page 102

Rear Panel of QFX3600 and QFX3600-I Devices on page 106

AC Power Cord Specifications for a QFX Series Device on page 292

Connecting AC Power to a QFX3500, QFX3600, or QFX3600-I Device on page 463

Connecting DC Power to a QFX3500, QFX3600, or QFX3600-I Device on page 466

Removing a Power Supply from a QFX3600 or QFX3600-I Device on page 658

Chapter 43: Replacing QFX3600 Components

Table of Contents