Juniper QFabric QFX3000-G Hardware Documentation page 390

QFX3000-G QFabric System Hardware Documentation
Chassis Lifting Guidelines for a QFX3600 or QFX3600-I Device
Related
Documentation
Chassis Lifting Guidelines for a QFX3500 Device
340
Mounting a QFX5100 Device in a Rack or Cabinet on page 435
The weight of a fully loaded QFX3600 or QFX3600-I device chassis is approximately
20.5 lb (9.3 kg). Observe the following guidelines for lifting and moving a QFX3600 or
QFX3600-I device:
Before installing a QFX3600 or QFX3600-I device, read the guidelines in
Preparation Checklist for a QFX3600 or QFX3600-I Device" on page 212
the intended site meets the specified power, environmental, and clearance
requirements.
Before lifting or moving the QFX3600 or QFX3600-I device, disconnect all external
cables.
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
General Safety Guidelines and Warnings on page 329
Installation Instructions Warning on page 337
Mounting a QFX3600 or QFX3600-I Device on Four Posts in a Rack or Cabinet on
page 458
Mounting a QFX3600 or QFX3600-I Device on Two Posts in a Rack or Cabinet on
page 455
The weight of a fully loaded QFX3500 device chassis is approximately 30.8 lb (14 kg).
Observe the following guidelines for lifting and moving a QFX3500 device:
CAUTION: If you are installing the QFX3500 device above 60 in. (152.4 cm)
from the floor, you must remove the power supplies, fan trays, and
management board before attempting to install the device, or ask someone
to assist you during the installation.
Before installing a QFX3500 device, read the guidelines in
for a QFX3500 Device" on page 213
power, environmental, and clearance requirements.
Before lifting or moving the QFX3500 device, disconnect all external cables.
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
"Site Preparation Checklist
to verify that the intended site meets the specified
Copyright © 2018, Juniper Networks, Inc.
"Site
to verify that