Figure 257: Installing A Control Board In A Qfx3008-I Interconnect Device - Juniper QFabric QFX3000-G Hardware Documentation

Related
Documentation
Taking a 16-Port QSFP+ Front Card Offline in a QFX3008-I Interconnect Device
Related
Documentation
Copyright © 2018, Juniper Networks, Inc.

Figure 257: Installing a Control Board in a QFX3008-I Interconnect Device

Control Board in a QFX3008-I Interconnect Device on page 53
Control Board LEDs on a QFX3008-I Interconnect Device on page 729
To prevent data loss, we recommend that you take a 16-port QSFP+ front card offline
before removing it from a QFX3008-I Interconnect device.
To take the front card offline in a QFX3008-I Interconnect device:
Use the
1. request chassis fpc interconnect-device name slot slot-number offline
command. Enter the name of the device in which the front card you want to remove
is installed, and the number of the slot from which you are removing the front card;
the slots are numbered from
Interconnect Device" on page
Use the show chassis fpc
2.
the state field in the command output shows that the card is offline, it is safe to remove
the front card. See "Removing a 16-Port QSFP+ Front Card from a QFX3008-I
Interconnect Device" on page
Installing a 16-Port QSFP+ Front Card in a QFX3008-I Interconnect Device on page 636
16-Port QSFP+ Front Cards in a QFX3008-I Interconnect Device on page 52
Chapter 41: Replacing QFX3008-I Components
through . See "Slot Numbering for a QFX3008-I
0 7
44.
CLI command to verify that the front card is offline. When
634.
CLI
633