Chassis Status Leds On A Qfx5100 Device; Figure 20: Chassis Status Leds On A Qfx5100 Switch; Table 10: Management Port Leds On A Qfx5100 Switch - Juniper QFX5100 Hardware Manual

Table 10: Management Port LEDs on a QFX5100 Switch

LED Color
Link/Activity Unlit
Green
Status Unlit
Green
Amber
Related
Documentation

Chassis Status LEDs on a QFX5100 Device

Copyright © 2017, Juniper Networks, Inc.
Table 10 on page 37 describes the management port LEDs.
State
Off
On steadily
Blinking or flickering
Off
On steadily
On steadily
Management Panel of a QFX5100 Device on page 32
Connecting a QFX5100 Device to a Network for Out-of-Band Management
The QFX5100 switch series has four status LEDs on the FRU side of the chassis, next to
the management ports (see

Figure 20: Chassis Status LEDs on a QFX5100 Switch

1— Status LEDs
2— em1–SFP management Ethernet port (C1)
Cage (socket for either 10/100/1000 Base-T
RJ45 SFP or 1GbE fiber SFP)
3— Reset
button, see caution statement below
CAUTION: Do not use the
under the direction of Juniper Networks Technical Assistance Center (JTAC).
Chapter 2: Chassis Components and Descriptions
Description
No link is established, there is a fault, or the link is down.
A link is established, but there is no link activity.
A link is established, and there is link activity.
Either the port speed is 10 M or the link is down.
The port speed is 1000 M.
The port speed is 100 M.
Figure 20 on page 37).
4— em0–RJ-45 (10/100/1000 Base-T)
management Ethernet port (C0)
5— RJ-45 console port (CON )
6— USB port
button to restart the power sequence unless
Reset
37