Figure 157: Attaching Rear Support Anchors To The Qfx3008-I Chassis In A; Four-Post Rack - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
408
NOTE: Earlier versions of the four-post rack mounting hardware did not
require the rear support anchors. If your four-post rack mounting hardware
includes spacer bars and two shelves the rear support anchors are not
required.
Secure the rear support anchors with the provided UNC 1/4-20 (right side) screws
11.
and M6 (left side) screws.
TIP: Because the rear support anchors are attached to the chassis
grounding points, it is best to connect the chassis to earth ground while
performing this step. See
Interconnect Device" on page 409
Figure 157: Attaching Rear Support Anchors to the QFX3008-I Chassis in a Four-Post
Rack
Connecting AC Power to a QFX3008-I Interconnect Device with Single-Phase Wiring
Trays on page 411
Powering On a QFX3008-I Interconnect Device on page 425
Rack Requirements for a QFX3008-I Interconnect Device on page 231
Cabinet Requirements for a QFX3008-I Interconnect Device on page 239
"Connecting Earth Ground to a QFX3008-I
for more information.
Copyright © 2018, Juniper Networks, Inc.