Figure 159: Connecting An Ac Power Cord To A Single-Phase Wiring Tray - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
412
Power cords appropriate for your geographical location. See
Specifications for a QFX3008-I Interconnect Device with Single-Phase Wiring Trays"
on page 283.
WARNING: Ensure that the power cords do not block access to device
components or drape where people can trip on them.
To connect AC power to a QFX3008-I Interconnect device with single-phase wiring trays
(see Figure 159 on page 412:
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the chassis.
Ensure that the wiring tray is fully inserted and latched securely in the chassis. See
2.
"Installing a Wiring Tray in a QFX3008-I Interconnect Device" on page
Set the switch, which is near the top of the wiring tray faceplate, to the OFF (O)
3.
position.
Locate the power cord or cords shipped with the device; the cords have plugs
4.
appropriate for your geographical location.
Insert the coupler end of the power cord into the AC appliance inlet on the wiring tray
5.
faceplate. See Figure 159 on page

Figure 159: Connecting an AC Power Cord to a Single-Phase Wiring Tray

Cord
retainer
If the AC power source outlet has a power device, set it to the OFF (0) position.
6.
Insert the power cord plug into an AC power source outlet.
7.
"AC Power Cord
412.
Copyright © 2018, Juniper Networks, Inc.
610.