Juniper QFabric QFX3000-G Hardware Documentation page 229

Table 54: Parts and Tools Required for Connecting an EX Series Switch to Earth Ground (continued)
Earthing
Terminal Grounding Cable
Switch Location Requirements
EX6210 Rear panel The grounding cable
of the must be the same
chassis gage as the power
(on lower feed cables and as
left side) permitted by the local
code.
EX8208 Left side 6 AWG (13.3 mm²),
of the minimum 60° C wire,
chassis or as permitted by the
local code
EX8216 Two 2 AWG (33.6 mm²),
earthing minimum 60° C wire,
terminals: or as permitted by the
local code
Left
side of
the
chassis
Rear
panel of
the
chassis
EX9204 Rear panel One 6 AWG
of the (13.3 mm²), minimum
chassis 60° C wire, or one that
complies with the
local code
EX9208 Rear panel One 6 AWG
of the (13.3 mm²), minimum
chassis 60° C wire, or one that
complies with the
local code
Copyright © 2018, Juniper Networks, Inc.
Grounding Lug Screws and
Specifications Washers
Panduit Two ¼-20
LCD2-14A-Q or x 0.5 in. screws
equivalent with #¼"
—provided split-washer
—provided
Two #¼" flat
washers—
provided
Panduit Two ¼-20
LCD2-14A-Q or x 0.5 in. screws
equivalent with #¼"
—provided split-washer
—provided
Two #¼" flat
washers—
provided
Panduit Two ¼-20 x
LCD2-14A-Q or 0.5 in. screws
equivalent with #¼"
—provided split-washer
—provided
Two #¼" flat
washers—
provided
Thomas&Betts Two ¼-20
LCN6-14 or x 0.5 in. screws
equivalent— with #¼"
provided split-washer—
provided
Two #¼" flat
washers—
provided
Thomas&Betts Two ¼-20
LCN6-14 or x 0.5 in. screws
equivalent— with #¼"
provided split-washer—
provided
Two #¼" flat
washers—
provided
Chapter 7: EX4300 Overview
Additional
Screwdriver Information
Phillips (+)
number 2
Phillips (+)
number 2
Phillips (+) See "Special
number 2 Instructions
to Follow
Before
Connecting
Earth Ground
to a Switch"
on page 180.
Phillips (+) See
number 2 Grounding
Cable and Lug
Specifications
for EX9200
Switches.
Phillips (+) See
number 2 Grounding
Cable and Lug
Specifications
for EX9200
Switches.
179