Juniper QFabric QFX3000-G Hardware Documentation page 388

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Chassis Lifting Guidelines for a QFX3100 Director Device
Related
Documentation
Chassis Lifting Guidelines for a QFX3008-I Interconnect Device
338
Advarsel Les installasjonsinstruksjonene før systemet kobles til strømkilden.
Aviso Leia as instruções de instalação antes de ligar o sistema à sua fonte
de energia.
¡Atención! Ver las instrucciones de instalación antes de conectar el sistema
a la red de alimentación.
Varning! Läs installationsanvisningarna innan du kopplar systemet till dess
strömförsörjningsenhet.
Laser and LED Safety Guidelines and Warnings for the ACX5000 Router
The weight of a fully loaded QFX3100 Director device chassis is approximately 41.2 lb
(18.7 kg). Observe the following guidelines for lifting and moving a QFX3100 Director
device:
Before installing a QFX3100 Director device, read the guidelines in
Checklist for a QFX3100 Director Device" on page 208
meets the specified power, environmental, and clearance requirements.
Before lifting or moving the QFX3100 Director device, disconnect all external cables.
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
General Safety Guidelines and Warnings on page 329
Installation Instructions Warning on page 337
Mounting a QFX3100 Director Device on Two Posts in a Rack or Cabinet on page 380
Mounting a QFX3100 Director Device on Four Posts in a Rack or Cabinet on page 381
The weight of a fully loaded QFX3008-I Interconnect device is approximately 650 lb
(295 kg). Observe the following guidelines for lifting and moving the device:
Before moving the device to a site, ensure that the site meets the power, environmental,
and clearance requirements specified in the
Interconnect Device" on page
Do not attempt to lift the QFX3008-I Interconnect device by yourself. We recommend
using a mechanical lift rated for at least 750 lb (340.2 kg) to install the QFX3008
device in a rack or cabinet. If you do not have a lift rated for 750 lb (341 kg), you must
to verify that the intended site
"Site Preparation Checklist for a QFX3008-I
210.
Copyright © 2018, Juniper Networks, Inc.
"Site Preparation