Juniper QFabric QFX3000-G Hardware Documentation page 555

Related
Documentation
Connecting a QFX3100 Director Device to a Network for Out-of-Band Management
Related
Documentation
Connecting a QFX3008-I Interconnect Device to a Copper-Based QFX3000-G QFabric
System Control Plane Network
Copyright © 2018, Juniper Networks, Inc.
Chapter 35: Cabling a Copper-Based Control Plane for the QFX3000-G QFabric System
Installing and Connecting a QFX3100 Director Device on page 377
Use the management port on your QFX3100 Director device to connect each Director
device in your Director group to your out-of-band management network.
NOTE: You cannot use the management port to perform the initial
configuration of the QFX3100 Director device. You must configure the
management port before you can successfully connect to the QFX3100
Director device using this port. See
Setup on a QFX3100 Director Group" on page
Ensure that you have an RJ-45 patch cable available.
To connect a QFX3100 Director device to a network for out-of-band management:
Connect one end of the Ethernet cable to the management port (labeled
1.
the Director device front panel).
Connect the other end of the Ethernet cable to your management device or
2.
management network.
Repeat these steps for the second Director device.
3.
Management Port Connector Pinouts for the QFX Series on page 260
Cable Specifications for Console and Management Connections for the QFX Series on
page 268
Connecting QFX3100 Director Devices to a Copper-Based QFX3000-G QFabric System
Control Plane Network on page 502
Connecting QFX3100 Director Devices to a Copper-Based QFX3000-M QFabric System
Control Plane Network
Connecting QFX3100 Director Devices to a Fiber-Based QFX3000-M QFabric System
Control Plane Network
Connecting a QFX Series Device to a Management Console on page 386
A QFX3000-G QFabric system control plane and management network is formed by
connecting the QFabric system devices in your network to two Virtual Chassis composed
of four EX4200 switches or four EX4300 each. QFX3008-I Interconnect Devices have
"Performing the QFabric System Initial
551.
on
MGMT
505