Juniper QFabric QFX3000-G Hardware Documentation page 907

Reconnecting the Director Device to the Control Plane
Copyright © 2018, Juniper Networks, Inc.
*
*******************************************************************************
Select the first field in the RAID Disk column and press the Spacebar to change
No
6.
the entry to Yes, to select a disk. The utility gives you the option to overwrite all the
data on the drive or to synchronize the data with that on the other drive.
Select to delete the corrupt data from the disk.
D
7.
When the Create New Array page appears again, select the second disk and press the
8.
Spacebar.
Select to create the array after both fields in the RAID Disk column are recognized
C
9.
as storage.
Select
Save changes then exit this menu
10.
When the RAID has been created. the adapter Properties page appears again and
shows the status as enabled.
Press the ESC key twice.
11.
Select Exit the Configuration Utility and Reboot
12.
Install the QFX3100 software image using either the QFabric USB install media or the
13.
QFabric Director Group recovery media.
Gracefully bring down the Director device. See
14.
Device" on page 559.
Reconnect cables and enable the interfaces. See
15.
to the Control Plane" on page
After restoring an inactive Director device or a corrupted RAID, reconnect the cables and
enable the interfaces:
Reconnect the cable from port
1.
6 to control plane VC1 .
Enable the interfaces on the EX4200 or E4300 that connect the Director device to
2.
both control plane VCs using the
On a QFX3000-M QFabric system, enable ge-0/0/40 and ge0/0/41.
Copper or fiber EX Series VC0 interfaces:
Chapter 57: Restoring QFX3100 Volumes
, and press Enter to start creating the array.
to complete the RAID recovery.
"Powering Off a QFX3100 Director
"Reconnecting the Director Device
857.
of the Director device to control plane VC0 and port
0
set interface <ge-x/y/z> command.
857