Juniper QFabric QFX3000-G Hardware Documentation page 604

QFX3000-G QFabric System Hardware Documentation
554
Note: please record your passwords for recovery purposes.
CAUTION: Carefully save your passwords for future reference, because
some cannot be recovered on a QFabric system.
Enter the QFabric system platform type.
12.
Supported platform types:
1. QFX3000-G
2. QFX3000-M
Please select product type: number corresponding to platform type
Confirm the initial configuration. Ensure that the information is accurate before
13.
proceeding.
Does the following configuration appear correct?
Director Group 0 IPv4/Prefix
Director Group 1 IPv4/Prefix
Director Group IPv4 Gateway
Director Group 0 IPv6/Prefix
Director Group 1 IPv6/Prefix
Director Group IPv6 Gateway
[2000:0001:0002:0003:0226:88ff:fe7b:e880]
QFabric Default Partition (IPv6 address) [2000:1:2:3::0a5e:c802/64]
QFabric Serial ID
Director Device Password
NOTE: Only addresses of the IP version(s) you entered will appear in the
configuration.
Confirm the initial setup.
14.
[y/n]: y
CAUTION: Resetting this initial configuration requires assistance from
Juniper Networks customer support or
Recovery Installation on the Director Group" on page
sure you are certain the values you entered are correct before you enter
yes.
The director device displays the configuration.
15.
Saving temporary configuration...
Configuring peer...
Configuring local interfaces...
Configuring interface eth0 with [10.49.214.74/24:10.49.214.254]
Configured interface eth0 with [10.49.214.74/24:10.49.214.254]
[10.94.200.9/24]
[10.94.200.10/24]
[10.94.200.250]
[2000:1:2:3::a5e:c809/64]
[2000:1:2:3::a5e:c80a/64]
[qfsn-0123456789]
[********]
"Performing a QFabric System
841. As a result, make
Copyright © 2018, Juniper Networks, Inc.