Juniper QFabric QFX3000-G Hardware Documentation page 896

QFX3000-G QFabric System Hardware Documentation
846
You may enter the configuration manually or restore from a backup.
Specify a backup file? [y/n] : y
Please specify the full path of the configuration backup file. :
/mnt/myusb/mybackup-20110907
Enter y to continue.
15.
Enter y and specify the path to the backup configuration file located on the external
16.
USB flash drive.
/mnt/myusb/mybackup-20110907
The following messages appear:
Saving temporary configuration...
Configuring peer...
connect error for 1.1.1.2:9001
Configuring local interfaces...
Configuring interface eth0 with [10.49.213.163/24:10.49.213.254]
Configured interface eth0 with [10.49.213.163/24:10.49.213.254]
Configuring QFabric software with initial pool of 4000 MAC addresses
[00:10:00:00:00:00 - 00:10:00:00:0f:3b]
Configuring QFabric address [10.49.213.50]
Reconfiguring QFabric software static configuration
Applying the new Director Device password
Applying the QFabric component password
First install initial configuration, generating and sharing SSH keys.
First install initial configuration, generating SSH keys.
connect error for 1.1.1.2:9001
Shared SSH keys.
Configuration complete. Director Group services will auto start within 30
seconds.
The Director device reboots from the local disk on which the software was just installed.
Exit the Director device session and log in to the QFabric default partition CLI.
Issue the request system software configuration-restore command and specify the
17.
path to the backup configuration file located on the external USB flash drive to load
the previously saved QFabric system configuration.
From the default partition, issue the request system reboot node-group all command
18.
to reboot all of the Node groups in the QFabric system to ensure that all Node devices
are running the same version of software as the Director-group.
user@switch> request system reboot node-group all
From the default partition, issue the request system reboot fabric command to reboot
19.
the Interconnect devices and the other components in the fabric in the QFabric system
to ensure that Interconnect devices are running the same version of software as the
Director group.
Copyright © 2018, Juniper Networks, Inc.