Figure 229: Qfx5100 Node Device Fiber-Based Control Plane Connections For Qfx3000-Gqfabric System - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
534
Figure 229: QFX5100 Node Device Fiber-Based Control Plane Connections for QFX3000-G
QFabric System
Use the following QFX5100 Node devices and EX Series switches for a fiber-based
QFX3000-G QFabric system control plane network:
QFX5100 Node devices with two 1-Gbps SFP modules installed in the management
ports labeled and
C0 C1
Virtual Chassis EX4200-24F or EX4300-48P switch members with an SFP+ uplink
module installed.
Before you begin to connect a QFX5100 Node device to the fiber-based QFX3000-M
QFabric system control plane network:
Install your QFabric system hardware (Director group, Interconnect devices, and Node
devices). For more information, see
Device" on page 377, "Installing and Connecting a QFX3008-I Interconnect Device" on
page 389, "Installing and Connecting a QFX3600 or QFX3600-I Device" on page
"Installing and Connecting a QFX3500 Device" on page 473
Connecting a QFX5100 Device" on page
Install your Virtual Chassis hardware (EX4200 or EX4300 switches). For more
information, see "Installing and Connecting an EX4200 Switch" on page
and Connecting an EX4300 Switch" on page
Create two Virtual Chassis of eight EX4200-24F switch members or four EX4300-48P
switch members.
See "Cabling EX4200 or EX4300 Series Switches Virtual Chassis for a QFX3000-G
QFabric System Control Plane" on page
See Configuring an EX4200, EX4500, or EX4550 Virtual Chassis (CLI Procedure) or
Configuring an EX2300, EX3400, or EX4300 Virtual Chassis.
Interconnect the two Virtual Chassis switches using the 10-Gigabit Ethernet SFP+
uplink ports. See "Interconnecting Two Virtual Chassis for Copper-Based QFX3000-G
QFabric System Control Plane Redundancy" on page
Ensure that you have installed 1-Gigabit Ethernet SFP transceivers in both management
ports labeled on each QFX5100 Node device (see
C0
Series Device" on page 709). For a list of supported transceivers and required cables,
see
The Hardware Compatibility Tool
Ensure that you have installed 1-Gigabit Ethernet SFP transceivers in the ports you are
using on each EX Series switch (see Installing a Transceiver). For a list of supported
transceivers, see
The Hardware Compatibility Tool
EX Series
.
"Installing and Connecting a QFX3100 Director
433.
492.
493.
.
.
EX Series
and "Installing and
491or "Installing
497.
"Installing a Transceiver in a QFX
Copyright © 2018, Juniper Networks, Inc.
453,