Figure 150: Connecting An Ac Power Cord To An Ac Power Supply In A Qfx3100 Director Device - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
384
Ensure that you have the following parts and tools available:
A power cord appropriate for your geographical location
To connect AC power to a QFX3100 Director device (see
Ensure that the power supplies are fully inserted in the QFX3100 Director device.
1.
Locate the power cords shipped with the QFX3100 Director device; the cords have
2.
plugs appropriate for your geographical location. See
for a QFX3100 Director Device" on page
WARNING: Ensure that the power cord does not block access to QFX3100
Director device components or drape where people can trip on it.
Insert the coupler end of the power cord into the AC power cord inlet on the AC power
3.
supply faceplate (see Figure 150 on page
Figure 150: Connecting an AC Power Cord to an AC Power Supply in a QFX3100 Director
Device
If the AC power source outlet has a power switch, set it to the OFF (O) position.
4.
Insert the power cord plug into an AC power source outlet.
5.
If the AC power source outlet has a power switch, set it to the ON (|) position.
6.
Repeat these steps for the second AC power supply.
7.
Press the power switch on the rear panel of the QFX3100 Director device to power on
8.
the device.
Figure 150 on page
"AC Power Cord Specifications
277.
384).
Copyright © 2018, Juniper Networks, Inc.
384):