Table 91: Console Port Connector Pinout Information - Juniper QFabric QFX3000-G Hardware Documentation

Related
Documentation
Console Port Connector Pinout Information

Table 91: Console Port Connector Pinout Information

Pin Signal
1 RTS Output
2 DTR Output
3 TxD Output
4 Signal Ground
Copyright © 2018, Juniper Networks, Inc.
list of supported transceivers for QFabric Systems is located at
https://pathfinder.juniper.net/hct/product/
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
Front Panel of a QFX3100 Director Device on page 30
Rear Cards in a QFX3008-I Interconnect Device on page 55
Port Panel of QFX5100-48S and QFX5100-48SH Devices on page 77
Port Panel of QFX5100-48T and QFX5100-48TH Devices on page 79
Port Panel of a QFX5100-24Q Device on page 81
Front Panel of a QFX3600 Device on page 104
Front Panel of a QFX3500 Device on page 122
The console port on a Juniper Networks device is an RS-232 serial interface that uses an
RJ-45 connector to connect to a console management device. The default baud rate for
the console port is 9600 baud.
Table 91 on page 259 provides the pinout information for the RJ-45 console connector.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to a device, use a combination of
the RJ-45 to DB-9 female adapter and a USB to DB-9 male adapter. You
must provide the USB to DB-9 male adapter.
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Chapter 11: Port and Interface Specifications
.
259