Juniper QFabric QFX3000-G Hardware Documentation page 468

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Connecting AC Power to a QFX3008-I Interconnect Device with Three-Phase Delta
Wiring Trays
418
Insert the power cord in the wire strain relief by compressing the wire strain relief to
7.
enlarge the opening. Pull enough cord through the strain relief to allow easy wiring
connections to the terminal block.
Remove first the plastic, then the metal retaining nuts from the wire strain relief, and
8.
place either the 90° connector or flat connector over the threaded portion of the wire
strain relief as shown in
Screw first the metal, then the plastic retaining nuts on the threaded portion of the
9.
wire strain relief to complete the assembly.
Route the wiring through the hole in the wiring tray, and using a number 2 Phillips (+)
10.
screwdriver, attach the connector to the wiring tray using the screws and washers you
removed in Step 5.
TIP: If you are ready to make the wiring connections to the terminal block,
see "Connecting AC Power to a QFX3008-I Interconnect Device with
Three-Phase Delta Wiring Trays" on page 418
a QFX3008-I Interconnect Device with Three-Phase Wye Wiring Trays"
on page 422.
Repeat Step 3 through Step
11.
Powering On a QFX3008-I Interconnect Device on page 425
Wiring Tray in a QFX3008-I Interconnect Device on page 58
Wiring Tray LEDs on a QFX3008-I Interconnect Device on page 735
A QFX3008-I Interconnect device is configured with six AC power supplies and two wiring
trays.
CAUTION: Mixing different types of wiring trays in the same chassis is not a
supported configuration.
CAUTION: To meet safety and electromagnetic interference (EMI)
requirements and to ensure proper operation, the QFX3008-I Interconnect
device must be adequately grounded before it is connected to power.
Figure 160 on page 414 or
10 for the other wiring tray.
Figure 161 on page 414.
or "Connecting AC Power to
Copyright © 2018, Juniper Networks, Inc.