Juniper QFabric QFX3000-G Hardware Documentation page 687

Copyright © 2018, Juniper Networks, Inc.
Ensure that the ejector levers are engaged in the horizontal ejector rail. If the levers
are not engaged, push the card's faceplate just inside the hinges of the levers until
the ejectors are engaged in the ejector rail.
Push both the ejector levers simultaneously toward the faceplate of the front card
7.
until the levers are flush against the faceplate and are fully engaged.
CAUTION: Ensure that you push the ejector levers evenly and that both
ejector levers are completely engaged. It is possible for the board to receive
power if only one of the levers is fully closed, causing a device malfunction.
Verify that the front card is installed correctly and functioning normally by checking
8.
the LEDs on the faceplate of the front card. The
be lit steady green a few minutes after the front card is installed.
Verify that the new device is inserted into the fabric using the
9.
inventory interconnect-devices
partition CLI.
root@qfabric> show fabric administration inventory interconnect-devices
Item
Interconnect device
IC-QFX3713490033
QFX3713490033/RE0
IC-QFXB3714010454
QFX3714010454/RE0
root@qfabric>
From the QFabric director, enter the following configuration mode CLI commands to
10.
remove the previous rear card from the inventory of QFabric system components and
associate the serial number of the new rear card with the alias of the previous card.
root@fabric# delete fabric aliases interconnect-devices
old-serial-numberalias-name
root@fabric# set fabric aliases interconnect-devices new-serial-numberalias-name
Commit the changes using the
11.
the old device to the new device.
Chapter 41: Replacing QFX3008-I Components
STATUS
operational mode command from the QFabric default
Identifier
command, which sends the configuration of
commit
LED and LED should
POWER
show fabric administration
Connection Configuration
Connected Configured
Connected
Connected Configured
Connected
637