Figure 167: Connecting The Qfx Series To A Management Console Through A; Console Server - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
Connecting a QFX Series Device to a Management Console
426
Installing an AC Power Supply in a QFX3008-I Interconnect Device on page 607
Connecting AC Power to a QFX3008-I Interconnect Device with Single-Phase Wiring
Trays on page 411
Connecting AC Power to a QFX3008-I Interconnect Device with Three-Phase Delta
Wiring Trays on page 418
Connecting AC Power to a QFX3008-I Interconnect Device with Three-Phase Wye
Wiring Trays on page 422
Powering Off a QFX3008-I Interconnect Device on page 562
The QFX Series has a console port with an RJ-45 connector. Use the console port to
connect the device to a management console or to a console server.
Ensure that you have an RJ-45 to DB-9 rollover cable available. An RJ-45 cable with an
RJ-45 to DB-9 adapter is provided with the device.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to the QFX Series, use a
combination of the RJ-45 cable and RJ-45 to DB-9 adapter supplied with the
device and a USB to DB-9 male adapter. You must provide the USB to DB-9
male adapter.
To connect the QFX Series to a management console (see
Figure 152 on page 387):
Connect one end of the Ethernet cable to the console port (labeled
1.
Connect the other end of the Ethernet cable into the console server (see
2.
Figure 151 on page 387) or management console (see
Figure 167: Connecting the QFX Series to a Management Console Through a Console
Server
Figure 151 on page 387
).
CON
Figure 152 on page 387).
Copyright © 2018, Juniper Networks, Inc.
and