Juniper QFabric QFX3000-G Hardware Documentation page 740

QFX3000-G QFabric System Hardware Documentation
Removing a Fan Module from an EX4300 Switch
690
The fan module in EX4300 switches is a hot-removable and hot-insertable
field-replaceable unit (FRU) installed in the rear panel of the switch: You can remove
and replace it without powering off the switch or disrupting switch functions.
Ensure that you have the following parts and tools available:
Phillips (+) screwdriver, number 2
An antistatic bag or an antistatic mat
A replacement fan module
NOTE: The fan module slots are at the left side of the rear panel on 24-port
and 48-port switches, and at the right side on 32-port switches.
Figure 297 on page 691
48-port switches except EX4300-48MP and EX4300-48MP-S switches.
The procedure is the same for 32-port switches.
how to remove a fan module from EX4300-48MP and EX4300-48MP-S
switches.
Place the antistatic bag or the antistatic mat on a flat, stable surface.
1.
Loosen the captive screws on the front faceplate of the fan module by using your
2.
fingers. If you are unable to loosen the captive screws by using your fingers, use the
screwdriver.
WARNING: To prevent injury, do not touch the fan with your hands or any
tools as you slide the fan module out of the chassis—the fan might still
be running.
Grasp the handle on the fan module and pull it firmly to slide the fan module out of
3.
the chassis.
Place the fan module in the antistatic bag or on the antistatic mat placed on a flat,
4.
stable surface.
Install the replacement fan.
5.
Tighten the captive screws on the faceplate of the fan module by using your fingers.
6.
If you are unable to tighten the captive screws by using your fingers, use the screwdriver.
shows how to remove a fan module from 24- port or
Figure 298 on page 691
Copyright © 2018, Juniper Networks, Inc.
shows