Table 144: Interconnect Device Port Mappings - Juniper QFabric QFX3000-G Hardware Documentation

Table 144: Interconnect Device Port Mappings

Interconnect
Device Virtual Chassis VC0
IC0 CB0, port 0
CB1, port 0
IC1
CB0, port 0
CB1, port 0
IC2 CB0, port 0
CB1, port 0
IC3
CB0, port 0
CB1, port 0
Copyright © 2018, Juniper Networks, Inc.
Chapter 35: Cabling a Copper-Based Control Plane for the QFX3000-G QFabric System
Ensure that you have installed 1-Gigabit Ethernet SFP transceivers in the ports you are
using on each EX4200 or EX4300 switch (see Installing a Transceiver). For a list of
supported transceivers, see
Ensure that you have four RJ-45 patch cables available for each Interconnect device.
For cable specifications, see
Connections for the QFabric System" on page
Use Table 144 on page 507
Chassis port mappings. Specific ports have been reserved on the Virtual Chassis to
connect to each of the QFX Series device types. Such design simplifies installation and
facilitates timely deployment of a QFabric system.
NOTE: The two Control Boards in each Interconnect device are labeled
CB0 and CB1 in Figure 218 on page 506
devices IC2 and IC3 are not shown in
the port mappings for the optional third and fourth Interconnect devices
to ge-0/0/39
to ge-1/0/39
to
ge-2/0/39
to
ge-3/0/39
to ge-0/0/38
to ge-1/0/38
to
ge-2/0/38
to
ge-3/0/38
The Hardware Compatibility Tool
"Cable Specifications for Copper-Based Control Plane
265.
to determine the QFX3008-I Interconnect device-to-Virtual
and Table 144 on page
Figure 218 on page 506
Virtual Chassis VC1
CB0, port 1 to
CB1, port 1 to
to
CB0, port 1
to
CB1, port 1
CB0, port 1 to
CB1, port 1 to
to
CB0, port 1
to
CB1, port 1
.
507. Interconnect
and describe
ge-0/0/39
ge-1/0/39
ge-2/0/39
ge-3/0/39
ge-0/0/38
ge-1/0/38
ge-2/0/38
ge-3/0/38
507