Table 166: 16-Port Qsfp+ Front Card Leds On A Qfx3008-I Interconnect; Table 167: 16-Port Qsfp+ Front Card Port Leds On A Qfx3008-I Interconnect - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Table 166: 16-Port QSFP+ Front Card LEDs on a QFX3008-I Interconnect Device
LED Color
Status Green
Amber
Power Unlit
Green
Amber
Table 167: 16-Port QSFP+ Front Card Port LEDs on a QFX3008-I Interconnect Device
LED Color
Link/Activity Unlit
Green
Status Unlit
Green
Related
Documentation
732
State
On steadily
Intermittent blinking
On steadily
Blinking
Off
On steadily
Blinking
Table 167 on page 732 describes the QSFP+ port LEDs.
State
Off
On steadily
Flickering
Off
On steadily
16-Port QSFP+ Front Cards in a QFX3008-I Interconnect Device on page 52
Installing a 16-Port QSFP+ Front Card in a QFX3008-I Interconnect Device on page 636
Description
Front card is operating normally.
The beacon feature has been enabled on
the card using the request chassis beacon
command.
Software is loading on the front card.
Front card has failed to boot properly and
needs to be reset or reinstalled. See
"Installing a 16-Port QSFP+ Front Card in
a QFX3008-I Interconnect Device" on
page 636.
There is no power to the front card, or the
front card is not fully seated in the chassis.
See "Installing a 16-Port QSFP+ Front Card
in a QFX3008-I Interconnect Device" on
page 636.
Front card is powered on.
Front card is offline.
Description
No link is established, there is a fault, or
the link is down.
A link is established, but there is no link
activity.
A link is established, and there is link
activity.
No transceiver is installed in the port, the
port is configured for a different interface,
or the transceiver is not supported.
A transceiver is installed in the port.
Copyright © 2018, Juniper Networks, Inc.