Figure 156: Installing A Qfx3008-I Interconnect Device In A Four-Post Rack - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

Figure 156: Installing a QFX3008-I Interconnect Device in a Four-Post Rack

Move the lift away from the rack.

Ensure the mounting brackets are flush with the front of the rack.

Install a mounting screw into each of the open front-mounting holes aligned with the

rack, starting from the bottom.

Visually inspect the alignment of the device. If the device is installed properly in the

rack, all the mounting screws on one side of the rack are aligned with the mounting

screws on the opposite side, and the device is level.

After ensuring that the device is aligned properly, tighten the screws.

In a four-post rack, hook the rear support anchors around the bottom rear flange of

the mounting shelf so that its holes line up with the grounding lug screw holes at the

bottom left and right corner of the chassis rear.

Chapter 29: Installing a QFX3008-I Interconnect Device

Table of Contents