Table 93: Rj-45 Management Port Connector Pinout Information - Juniper QFabric QFX3000-G Hardware Documentation

Related
Documentation
RJ-45 Management Port Connector Pinout Information

Table 93: RJ-45 Management Port Connector Pinout Information

Pin Signal
1 TRP1+
2 TRP1-
3 TRP2+
4 TRP3+
5 TRP3-
6 TRP2-
7 TRP4+
8 TRP4-
Management Port Connector Pinout Information for an EX4200 Switch
Copyright © 2018, Juniper Networks, Inc.
Management Port LEDs on a QFX3100 Director Device on page 722
Management Port LEDs in the QFX3600 and QFX3600-I Device on page 750
Management Port LEDs on a QFX3500 Device on page 758
Management Port LEDs on a QFX5100 Device on page 739
QFX10002 Management Port LEDs
QFX10000 Control Board LEDs
QFX5200 Management Port LEDs
QFX5110 Management Port LEDs
Table 93 on page 261 provides the pinout information for the RJ-45 connector for the
management port on Juniper Networks devices.
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
Transmit/receive data pair 4
The management port on the switch uses an RJ-45 connector to connect to a
management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T
connection. Two LEDs on the port indicate link/activity on the port and the administrative
status of the port. See Management Port LEDs in EX3200 Switches and
Port LEDs in EX4200 Switches" on page
Table 92 on page 260 provides the pinout information for the RJ-45 connector. An RJ-45
cable, with a connector attached, is supplied with the switch.
Chapter 11: Port and Interface Specifications
807.
"Management
261