Figure 224: Qfx3100 Director Group Control Plane Connections For Qfx3000-Gqfabric System Using Copper-Based Control Plane - Juniper QFabric QFX3000-G Hardware Documentation

Hide thumbs Also See for QFabric QFX3000-G:

Table of Contents

QFX3000-G QFabric System Hardware Documentation

Documentation

Connecting QFX3100 Director Devices in a Director Group

Remove the rubber safety cap from the SFP+ optical transceiver in port

of the second Virtual Chassis. Save the cap.

Insert the cable connector into the optical transceiver.

through Step

assignments in

Table 148 on page 521

Secure the cables so that they are not supporting their own weight. Place excess cable

out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain

their shape.

Do not bend fiber-optic cables beyond their minimum bend

radius. An arc smaller than a few inches in diameter can damage the cables

and cause problems that are difficult to diagnose.

Do not let fiber-optic cables hang free from the connector. Do not allow

fastened loops of cables to dangle, which stresses the cables at the

fastening point.

Installing and Connecting a QFX3100 Director Device on page 377

A QFabric system requires two QFX3100 Director devices interconnected as a QFX3100

Director group (see

Figure 214 on page 500

Figure 224: QFX3100 Director Group Control Plane Connections for QFX3000-G QFabric

System Using Copper-Based Control Plane

for each uplink module port, following the port

Table 149 on page

Figure 216 on page

Chapters

Table of Contents