Juniper QFabric QFX3000-G Hardware Documentation page 244

QFX3000-G QFabric System Hardware Documentation
Table 58: Parts and Tools Required for Connecting an EX Series Switch to Earth Ground (continued)
Earthing
Terminal Grounding Cable
Switch Location Requirements
EX2300-C Rear panel 14 AWG (2 mm²),
of the minimum 90° C wire,
chassis or as permitted by the
local code
EX2300 Rear panel
of the
chassis
EX3200 Rear panel 14 AWG (2 mm²),
of the minimum 90° C wire,
chassis or as permitted by the
local code
194
Grounding Lug
Specifications
Panduit
LCC10-14AW-L or
equivalent—
not provided
EX2300 switches EX2300 switches
except except
EX2300-24MP and EX2300-24MP
EX2300-48MP and
models—14 AWG (2 EX2300-48MP
mm²), minimum models—Panduit
90° C wire, or as LCC10-14AW-L or
permitted by the equivalent— not
local code provided
EX2300-24MP and EX2300-24MP
EX2300-48MP and
models—14-10 EX2300-48MP
AWG STR (2.5-6 models—Panduit
mm²), 12-10 AWG LCA10-10L or
SOL (4-6 mm²) equivalent— not
minimum 90° C provided
wire, or as
permitted by the
local code—not
provided
Panduit
LCC10-14BWL or
equivalent—
not provided
Screws and
Washers Screwdriver
Two Phillips (+)
10-32 x .25 in. number 2
screws with #10
split-lock
washer—
not provided
Two #10 flat
washers—not
provided
EX2300 switches Phillips (+)
except number 2
EX2300-24MP
and
EX2300-48MP
models
Two 10-32 x
.25 in. screws
with #10
split-lock
washer— not
provided
Two #10 flat
washers—not
provided
EX2300-24MP
and
EX2300-48MP
models
One Pan
Phillips M 4 x 6
mm Nickel
plated screw—
provided
Two 10-32 Phillips (+)
x .25 in. screws number 2
with #10
split-lock
washer—
not provided
Two #10 flat
washers—
not provided
Copyright © 2018, Juniper Networks, Inc.
Additional
Information
See "Special
Instructions
to Follow
Before
Connecting
Earth Ground
to a Switch"
on page 180.