Figure 252: Removing A Side Fan Tray From A Qfx3008-I Interconnect; Device - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
624
Phillips (+) screwdriver, number 2
To remove an air filter from a QFX3008-I Interconnect device (see
and Figure 253 on page 625):
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the chassis.
Unscrew the captive screw, located on each cover panel, counterclockwise using your
2.
fingers. If you cannot easily unscrew the captive screw with your fingers, use the
screwdriver.
Hold the screw on the cover panel with one hand while holding the handle with the
3.
other. Pull firmly on the screw to detach the cover panel.
Pull the air filter tab to the side and slide the filter out of the fan tray module.
4.
Figure 252: Removing a Side Fan Tray from a QFX3008-I Interconnect Device
Figure 252 on page 624
Copyright © 2018, Juniper Networks, Inc.