Figure 239: Installing An Hdd Module In A Qfx3100 Director Device - Juniper QFabric QFX3000-G Hardware Documentation

QFX3000-G QFabric System Hardware Documentation
Related
Documentation
0 1
Slot 1 2
602
Insert the HDD module into the HDD module slot, and gently push the module all the
5.
way into the slot until the module is seated flush in the HDD module slot.
CAUTION: If backpressure prevents the HDD module from seating flush
in the HDD module slot, remove the HDD module from the slot and retry
the procedure, taking care to ensure that the HDD module is properly
aligned with the HDD module slot.
Tighten both screws on the HDD module, using your fingers.
6.

Figure 239: Installing an HDD Module in a QFX3100 Director Device

Tighten captive screws.
0 1
Slot 1
2
Loosen captive screws.
HDD Modules in a QFX3100 Director Device on page 33
Loosen captive screws.
Rear Panel of a QFX3100 Director Device on page 30
0 1
Slot 1 2
Troubleshooting HDD Module Failures in a RAID Volume on page 849
0
1
Slot
1 2
Copyright © 2018, Juniper Networks, Inc.
Tighten captive screws.
Ti
0 1
Slot 1
2
Tighten captive screws.
Ti
0
1
Slot 1 2