Juniper QFabric QFX3000-G Hardware Documentation page 948

QFX3000-G QFabric System Hardware Documentation
Table 244: Alarm Terms and Definitions (continued)
Term Definition
Alarm types Alarms include the following types:
Chassis alarm—Predefined alarm triggered by a physical condition on the device such as a power supply
failure or excessive component temperature.
Interface alarm—Alarm you configure to alert you when an interface link is down. Applies to
fibre-channel
alarm for the link-down condition, or have the condition ignored.
System alarm—Predefined alarm that might be triggered by a missing rescue configuration, failure to
install a license for a licensed software feature, or high disk usage.
Related
Documentation
Chassis Alarm Messages on a QFX3008-I Interconnect Device
898
, and
management-ethernet
Chassis Alarm Messages on a QFX3008-I Interconnect Device on page 898
Chassis Alarm Messages on a QFX3500 Device on page 905
Interface Alarm Messages on page 908
show chassis alarms
show system alarms
Chassis alarms indicate a failure on the device or one of its components. Chassis alarms
are preset and cannot be modified.
The chassis alarm message count is displayed on the LCD panel on the front of the device.
To view the chassis alarm message text remotely, use the
Chassis alarms on a QFX3008-I Interconnect device have two severity levels:
Major (red)—Indicates a critical situation on the device that has resulted from one of
the conditions described in
immediate action.
Minor (yellow or amber)—Indicates a noncritical condition on the device that, if left
unchecked, might cause an interruption in service or degradation in performance. A
yellow alarm condition requires monitoring or maintenance.
Table 245 on page 899 describes the chassis alarm messages on a QFX3008-I Interconnect
device.
interfaces. You can configure a red (major) or yellow (minor)
Table 245 on page 899. A red alarm condition requires
Copyright © 2018, Juniper Networks, Inc.
ethernet
CLI command.
show chassis lcd
,