Juniper QFabric QFX3000-G Hardware Documentation page 601

CHAPTER 38
Performing the Initial Configuration
Performing the QFabric System Initial Setup on a QFX3100 Director Group
Copyright © 2018, Juniper Networks, Inc.
Performing the QFabric System Initial Setup on a QFX3100 Director Group on page 551
You must perform the initial setup of the QFX3100 Director group through the console
port. (Before configuring the QFX3100 Director group, see
QFX3100 Director Device" on page
Before you begin connecting and configuring a QFX3100 Director group, set the following
parameter values on the console server or PC:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
Stop Bits—1
DCD State—Disregard
NOTE: When you use the SecureCRT client to connect to a Director device
for the initial setup of a QFabric system, the backspace key does not work.
As a workaround, use the Shift+Delete key combination in SecureCRT as a
backspace key equivalent or use a different UNIX client to support the
backspace key natively.
The initial setup requires that you specify certain values for your QFabric system. These
include:
Software serial number for your QFabric system (found in the e-mail containing the
software serial number that you received from Juniper Networks when you purchased
your QFabric system)
IP addresses and a default gateway IP address for your QFabric system default partition
IP addresses for your Director group device management ports
"Installing and Connecting a
377.)
551